Dual Purpose Timber Treatment Gel 5kg

Details

Active Content
1.100%w/w Propicanazole, 1.125%w/w 3-lodo-2-propynyl-butyl-carbamate 0.344%w/w Permethrin

HSE No: 7396

Appearance: Clear Amber Gel

Odour: Mild

User Friendly
Micro Timber Gel carries no formal EC hazard ratings when used as directed. The product is not classified under the Chemicals (Hazards and Packaging) Chip Regulations 1996.
Exclude unprotected persons / animals or use physical barrier until treated surfaces are touch dry. Truly water based contains no Aromatic / Hydrocarbon / Glycol Ester solvents.

Specifying
All Permagard timber preservatives are approved for use under the HSE Control of Pesticide Regulations 1986 for use as directed.
All Bats are protected under the Wildlife and countryside Act 1981. Before treating any structure used by Bats, consult English Nature, Scottish Natural Heritage or the Countryside Council for Wales.
For the pre-treatment and remedial treatment of timber where access is restricted or where treatment by conventional fluid methods may not be adequate.
This would include timber which is particularly prone to decay such as wall plates, joists and rafter ends, gutter boards, soffits, lintels etc. Large cross section beams particularly in old buildings and timbers permanently in contact with the ground.

Method of Use
Apply Micro Timber Gel to the timber by using a caulking gun or by brush, trowel or gloved hand liberally covering the surface. Injection into the timber can also be used and is particularly recommended when treating Death Watch Beetle.

Preparatory Works
Check the structural integrity of the timbers to be treated and remove any severely infested timber. Ensure that any new timber is treated with a suitable preservative paying particular attention to cut ends.
In areas affected by fungal decay take all necessary actions to eliminate the source of dampness and to promote drying out.
Thoroughly clean all timbers – vacuum cleaning preferred.

Micro Timber Gel continues to penetrate over a long period of time depending on the rate of application and the absorption characteristics of the timber. Micro Timber Gel can leave a slight deposit on the surface of treated timber. Not for use on timbers to be painted or glued. Cover water/fish tanks with polythene sheeting. Display warning notices at strategic points prior to treatment and leave on site after treatment. Ensure written safety details are given to persons due to occupy treated areas.

Product Data
Coverage: Brush application at the rate of 100g – 200g of Gel per square metre of timber surface.
The rate of application however will depend on the degree of hazard and the dimensions of the timber being treated.

Packaging
5 kilo plastic containers

Drying Time
Dependent upon the hardness and absorption of the timber as the product continues to penetrate over a long time.
Storage In sealed containers away from excessive heat or frost. Stir if necessary.
Flash Point Above 60 Centigrade

FOR PROFESSIONAL USE ONLY