Newton HydroCoat 903-P Primer 5L
A concrete primer for use before the application of cementitious waterproofing membranes and coatings.
Newton Concrete Primer
Newton HydroCoat 903-P is a concrete primer that is designed to be applied prior to the installation of Newton’s range of high performance cementitious waterproofing membranes. It is also a highly effective primer for concrete repair and floor coating products, minimising the risk of debonding from internal and external concrete substrates. The primer increases the adhesion of cementitious slurries, coatings and concrete repair products to the concrete substrate.
The waterproof membrane primer is simple to apply and boasts a very quick application time. This means you can apply the subsequent products without delay - even during wetter months. Newton HydroCoat 903-P can also be used on both new and damp concrete.
Uses of HydroCoat 903-P Concrete Primer
Newton HydroCoat 903-P is a primer for concrete - designed for use before the application of the following:
- cementitious waterproofing membranes
- levelling compounds
- concrete repair products
- floor coating products
Applying HydroCoat 903-P Primer
Newton HydroCoat 903-P concrete floor primer is simple and quick to apply. It can be applied over new and damp concrete, using the following methods:
- airless spray
The Primer is very quick to cure and is ready for subsequent application of cementitious membranes within 40 mins at 25ºC and within 90 mins at 5ºC.
Permagard - Providing Solutions. Inspiring Confidence.
Permagard are proud to stock a wide range of Newton membranes and waterproofing products. If you have any questions about Newton Concrete Primers or liquid waterproofing membranes contact our technical team on 0117 982 3282.
- Extremely quick to apply – 10m²/min is possible.
- Suitable for application onto damp/wet concrete.
- Suitable for application onto new concrete > 20N/mm².
- Increases the adhesion of cementitious slurries, coatings and repair products to the concrete substrate.
- Very quick curing – the membrane or coating can be applied within 40 mins at 25ºC and within 90 mins at 5ºC.
|Dilution:||Ready to use|
|Coverage:||Approx. 100-200 ml/m² depending on the porosity of the substrate. 50 - 100m² per unit.|
|Country of Manufacture:||United Kingdom|
Need more information?
Thank you for leaving a review on this product!
If you need more help, check out the downloads for more product information, or our fantastic Help & Advice centre!
Review this product
Share your thoughts about this product with other customers, write a review.
- Newton HydroCoat 903-P Primer Technical Data Sheet (1,142.4 KB)
- Newton HydroCoat 903-P Primer Safety Data Sheet (306.1 KB)